Battery, Lipo (Lithium Polymer) Battery
2 x 3.7V 18650 Lithium Polymer (Lipo) Battery Holder
2 x 3.7V 18650 Lithium Polymer (Li-Po) Battery Holder (2 Cell 3.7VÂ 18650 Lithium Polymer (Lipo) Battery Holder)
Related products
-
Battery, Bonka Lipo Battery
Bonka 11.1V 460mAh 45C 3S Ultra Light U2 Series Lipo Battery
Lithium Polymer (Lipo) batteries are a type of battery now used in many consumer electronics devices. They have been gaining in popularity in the radio control industry over the last few years and are now the most popular choice for anyone looking for long run times and high power
The 460 mAh 45C 3S1P Bonka Lipo battery is a great choice which is specially designed for high power output such as for Quadcopters, Airplanes, RC Boat, RC Cars, etc.
SKU: n/a -
Battery, Bonka Lipo Battery
Bonka 11.1V 600mAh 45C 3S Ultra Light U2 Series Lipo Battery
Lithium Polymer (Lipo) batteries are a type of battery now used in many consumer electronics devices. They have been gaining in popularity in the radio control industry over the last few years and are now the most popular choice for anyone looking for long run times and high power
The 600 mAh 45C 3S1P Bonka battery is a great choice which is specially designed for high power output such as for Quadcopters, Airplanes, RC Boat, RC Cars, etc.
SKU: n/a -
Battery, Battery Chargers
CN3791 12V MPPT Solar Charger Module
This is a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provides you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargeable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the solar charger and your battery into the other and you are good to start charging!
Solar maximum power point tracking (MPPT) is to ensure that the light intensity change, photovoltaic cells output maximum power, to make full use of solar energy. In general, need to use a switch-mode DC-DC converter to realize the MPPT function, keep the output voltage, and charging current product maximize (output).The output of the Solar Charger is intended to charge a single polymer lithium-ion cell. The load should be connected in parallel with the battery. Each Solar Charger comes equipped with a CN3791 power tracking battery charging circuit and pre-installed four 2-pin JST/PH2.0 connectors.SKU: n/a
There are no reviews yet.