YF-G1 DN25 1 inch Water flow sensor used for flow measurement it consists of a plastic valve body, a water rotor, and a hall-effect sensor. When water flows through the rotor, rotor rolls. Its speed changes with different rate of flow. The hall-effect sensor outputs the corresponding pulse signal. This one is suitable to detect flow in water dispenser or coffee machine.
Specifications of 1 inch Water Flow Sensor – YF-G1 DN25:-
Features of 1 inch Water Flow Sensor – YF-G1 DN25:-
This small 3.5-inch touch screen module is designed specially for Arduino UNO. This is ideal for DIY anywhere, anytime, and does not require any separate power source or case to hold it. The screen also comes with a stylus to interact with the small screen.
Features of 3.5 inch TFT LCD Touch Screen Display Shield for Arduino Uno:-
The Proto Screw Shield is the ultimate breakout board for an Arduino. It combines a prototyping shield with a full set of 3.5 mm screw terminal blocks. The proto shield part lets you build custom circuitry and then you can easily & securely connect wires and sensors to the terminal blocks. Great for panel mounts, buttons, sensors, enclosures etc.
Proto Screw Shield is Pre-Assembled so that it can be directly screwed onto the thread posts. It isreliable and convenient.
The Arduino Proto Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including a large prototyping space of both connected and unconnected 0.1 spaced through-holes, a reset button, LED for D13 pin indicating.
The LilyPad 328 ATmega328P Main Board 16M is an Arduino-program micro-controller design to be easily integrated into e-textiles and wearable projects. It offers the same functionality you find in other Arduino boards, in a lightweight, round package design to minimize snagging and profile. With wide tabs that can be sewn down and connect with conductive thread.
The LilyPad Arduino consists of an ATmega328 with the Arduino bootloader and a minimum number of external components to keep it as small (and as simple) as possible.
This board will run from 2V to 5V and offers large pin-out holes that make it easy to sew and connect. Each of these pins, with the exception of (+) and (-), can control an attached input or output device (like a light, motor, or switch).
Each LilyPad was creatively designed to have large connecting pads to allow them to be sewn into clothing. Various input, output, power, and sensor boards are available. They’re even washable!
You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that your microcontroller has a limited number of PWM outputs! Here is the Servo Driver Module Shield 16 Channel to help you out!!!
What now? You could give up OR you could just get our handy PWM and Servo driver shield. Its now Arduino-ready and works with any Arduino that uses shields: Uno, Mega, ADK, its all good.
